McCormick XTX 200- Nie działa EHR

[jacok628 0]

mccormic xtx200 2006 rok przestał działac ehr kod błedu SPN2174 FMI31 .MOZE KTOS WIEC CO ON OZNACZA.

[Hvelektronik 13]

Witam pierwszy błąd o czujnika położenia ramion

 

Hitch Error Code 2174
Fault Description.
Hitch position (lift arm) potentiometer circuit failed, position potentiometer signal voltage outside the 0.3 to 5.0 volt
limit.
Response.
Fault Category - LIMP. Hitch enable light will illuminate and the hitch will only operate for 1.5 seconds using the
hitch up/down switch or hitch remote switches repeatedly.
Possible Cause.
1. Bad hitch position potentiometer.
2. Bad hitch position potentiometer circuit short to voltage above 5 volts.
3. Bad hitch position potentiometer circuit short to ground.
IMPORTANT: Before carrying out the following tests, refer to “CIRCUIT TESTING” on page 16.
Circuit Checks/Corrective Action.
1. Check the hitch position potentiometer is located correctly into the mounting bracket and the retaining
nut is tight. Also check the potentiometer link arm located correctly retaining allen screw is tight.
2. Check the hitch position potentiometer.
3. Check the hitch position potentiometer circuit.

 

[jacok628 0]

witam potencjometr wymieniony wyskoczył błąd 2203 podnośnik nadal nie działa dodam że w górę przyciskami w błotnikach reaguje poszedł na 100 % a w dół zero reakcji

Tylko na agroFakt.pl:

Gdzie kupić maszyny John Deere na Pomorzu? zobacz »

[Hvelektronik 13]

witam

Hitch Error Code 2203
Fault Description.
The Hitch position is above the upper limit.
Response.
Fault Category - DEGRADED 1. Hitch enable light will illuminate and the hitch will operate under default settings
only.
Possible Cause.
1. Hitch position command (cab) potentiometer moved during power down.
2. Bad hitch position command (cab) potentiometer.
3. Bad hitch position command (cab) potentiometer circuit.
IMPORTANT: Before carrying out the following tests, refer to “CIRCUIT TESTING” on page 16.
Circuit Checks/Corrective Action.
1. Press and hold the hitch up/down switch in the momentary position or the hitch remote down switch
down switch until the hitch upper limit is reached.
2. Check the hitch position command potentiometer.
3. Check the hitch position command potentiometer circuit.

 

[Che_Slav 0]

Witam, 

W moim przypadku oprócz ww. kodu błędu Ehr 2174 pojawił się drugi błąd Ehr 1501 oraz błąd Scr 03dE06. Co oznaczają te dwa błędy? 

Z góry dziękuję za odpowiedź i pozdrawiam.